Pneumatic valves and hydraulic
Pneumatic valves and hydraulic pressure based on a certain air, water or oil as a power source, an air cylinder (or cylinders) and the movement of the piston to drive the valve, general pneumatic air pressure is less than 0.8MPa, hydraulic pressure or low oil pressure is 2.5MPa ~ 25MPa. As for driving the diaphragm; rotary gas, liquid drive means for driving the ball, butterfly or plug. The driving force of hydraulic devices, suitable for driving large diameter valves. Such as for driving plug, ball and butterfly valves must be reciprocation conversion surface of the piston rotary motion. In addition to the use of an air cylinder or a hydraulic cylinder piston to drive, there is the use of pneumatic diaphragm-driven, and the driving force is small because of the trip, it is mainly used to adjust the valve.
Manual valve is a valve basic driving mode. It includes a hand wheel, lever or wrench two direct drive and driven through the transmission mechanism. When the valve start torque is large, it can be driven by a gear or worm gear, in order to achieve the purpose of omission. Gear sub spur gear and bevel gear drive. Gear reduction ratio, suitable for gate and globe valves, worm gear reducer relatively large for flash cocks, ball valves and butterfly valves
Address: no. 66 jinhua road, shangjie valve industrial park, zhengzhou city, henan province